Remoter 3.0 crash when adding new macro

[name00]

Hi there,
Currently I have no macros. When I start an SSH session and tap the macros icon Remoter crash (every time). I can start recording a macro by using the Macros Manager but then when I try to stop the recording Remoter crash.
I used to have a macro (recorded on an older version) and before I deleted it taping the macros icon did not cause a crash and I could play the macro.

Another unrelated issue. It is possible to have two sessions running at the same time (say SSH and VNC), but there is no way to switch between them. i.e. after starting the second session there is no way to go back to the first session (if there is a way I could not find it).

Last one, if I open an SSH session and then a VNC over SSH session Remoter crash (every time). Opening just one of the sessions works fine.

Thanks, and keep up the good work

[raf]

Hi name00,

Version 3.0.1 was submitted to Apple last night to correct this and some other issues, please see here:
http://forum.rafsoftware.com/viewtopic.php?f=2&t=387

About your other questions:

Another unrelated issue. It is possible to have two sessions running at the same time (say SSH and VNC), but there is no way to switch between them. i.e. after starting the second session there is no way to go back to the first session (if there is a way I could not find it).
Last one, if I open an SSH session and then a VNC over SSH session Remoter crash (every time). Opening just one of the sessions works fine.

No, having two sessions running simultaneously is not supported at the moment. But it is in the pipeline!

Thanks!,

Raf.