Page 1 of 1

Auto-Reconnect does not work

PostPosted: Thu Sep 13, 2012 5:13 pm
by speedyuy
Hi!
I am using Remoter v 3.6.3 on Ipad 2 with iOS 5.1.1.

When I lose the connection to the VNC server (tried with Real VNC and Ultra VNC) I get the prompt "... Do you want to reconnect?".
Even if I select Auto-Reconnect in options it doesn't reconnect automatically, it shows me the option to reconnect. Isn't that the expected behaviour when Auto-Reconnect isn't selected?
I think this is the best feature of Remoter VNC but I can't get it to work properly. Whis this option I would know Remoter is always connected to the server.
I'm sending a screen capture of the reconnection prompt.

Thanks!
Emilio

Re: Auto-Reconnect does not work

PostPosted: Thu Sep 20, 2012 9:06 am
by raf
Remoter only reconnects based under this conditions: (as of 3.8.0)

-The Remoter Config option is on
-A valid disconnect reason for reconnect happened: disconnected by server, time out, lost connection to remoter fusion or unknown
-The time the session was connected was at least 30 seconds (this to prevent rapid reconnect-disconnect cycle)

As long as those options are met, Remoter should try to reconnect.

Re: Auto-Reconnect does not work

PostPosted: Sun Sep 23, 2012 11:19 pm
by speedyuy
Thanks Raf!

What do you mean by "Remoter Config option is on"?
It does meet the other two conditions but it doesn't reconnect automatically, it asks to reconnect.

PS I tried the latest 3.8.0 version

Re: Auto-Reconnect does not work

PostPosted: Tue Sep 25, 2012 10:50 am
by raf
I was talking about the auto reconnect option in Remoter Config. But I'm sure you have it on.
I'll be looking into this. Thanks for the feedback!,
Raf.

http://trac.remoterlabs.com/index.fcgi/ticket/497