No MAC-adress configured, Wake-On-Lan package cannot be send
Posted: Fri Jul 08, 2011 4:06 pm
Hi Raf,
it's a shame but I have problems setting up _any_ (first) connection from my IPad 2 (WLAN) to a Linux PC (LAN).
I was using only the IP-Adress and a valid username and password - but I think remoter does not come so far.
I can ping the IP from my IPad with e.g. "Free Ping" successfully.
I've purchased the SSH-Addon and that was my first try to connect my Linux-Laptop.
Without success.
Now I've tried a VNC-connection after setting up vino on my host.
Without success.
Both times I got the error-message (German) "Keine MAC-Adresse eingerichtet, Wake-On-Lan Paket kann nicht gesendet werden"
Translation in English: "No MAC-adress configured, Wake-On-Lan package cannot be send"
I've checked a MAC-adress of my IPad in "General settings - Info - WiFi-Address" and identified a MAC-Adress which is also accepted and shown by my internet WLAN-router.
I'm not unfamiliar with linux and ssh/vnc so I think it must be a basic problem.
What is missing? - Where is my fault?
best regards
Jens
Remoter Version: 2.4.1 installed on IPad 2 iOS 4.3.2 (German Version - maybe that is a problem?)
it's a shame but I have problems setting up _any_ (first) connection from my IPad 2 (WLAN) to a Linux PC (LAN).
I was using only the IP-Adress and a valid username and password - but I think remoter does not come so far.
I can ping the IP from my IPad with e.g. "Free Ping" successfully.
I've purchased the SSH-Addon and that was my first try to connect my Linux-Laptop.
Without success.
Now I've tried a VNC-connection after setting up vino on my host.
Without success.
Both times I got the error-message (German) "Keine MAC-Adresse eingerichtet, Wake-On-Lan Paket kann nicht gesendet werden"
Translation in English: "No MAC-adress configured, Wake-On-Lan package cannot be send"
I've checked a MAC-adress of my IPad in "General settings - Info - WiFi-Address" and identified a MAC-Adress which is also accepted and shown by my internet WLAN-router.
I'm not unfamiliar with linux and ssh/vnc so I think it must be a basic problem.
What is missing? - Where is my fault?
best regards
Jens
Remoter Version: 2.4.1 installed on IPad 2 iOS 4.3.2 (German Version - maybe that is a problem?)